Sani-System Liquid Sanitizer Concentrate
The industry's only EPA & NSF approved sanitizer delivers reliable, effective results every time.
Liquid Sanitizer Concentrate is the only EPA & NSF approved
sanitizer for use in water softeners and reverse osmosis units. It's
proven to kill 99.99% of harmful bacteria without using chlorine,
oxidizers or acids that can harm system equipment, parts and resin. Each
packet of concentrated formula sanitizes equipment in just 60 seconds
and is available in exact pre-measured doses for both water softeners
and RO units. Sani-System's no-mess ease and accuracy answers our
industry's most important sanitizing concerns. Sani-System is effective,
efficient and easy to use - it's as simple as that!
Reverse Osmosis (RO) Units:
Shut off water supply to the RO unit and remove membrane and all
filters. If applicable, turn off pump. Use rubber gloves and store
filters and membranes in water to prevent damage.
2. Open pure water faucet and depressurize the system
Pour entire packet of Sani System RO Unit Sanitizer directly into the
first main housing unit and re-install the cartridge (a dummy filter may
be required for newer models). Make sure pure water faucet is closed
and turn on the water supply
Allow system to fill with water. Time will vary depending on water
pressure. However, system should be full within 5-10 minutes without the
filter or membrane installed. Once full, let system set for 60 seconds
then flush system two times.
5. Replace or re-install filters and membrane.